You are configuring the dhcp relay agent role on a windows server.

1. Which feature is used to configure a DHCP relay agent in Windows Server 2016?
2. How to configure a DHCP relay agent?
3. Which of the following roles must be installed in order to deploy a DHCP relay agent on Windows Server 2016?
4. What is Relay Agent in DHCP server?
5. How do I add IPv4 DHCP relay agent protocol?
6. Where does DHCP relay agent should be installed?
7. How do I use DHCP relay?
8. Which DHCP request option fills in the relay agent IP address?

Which feature is used to configure a DHCP relay agent in Windows Server 2016?

In Windows Server 2016, Remote Access role is required to configure DHCP Relay Agent.

How to configure a DHCP relay agent?

To enable DHCP service on the Server, click Server and click Services. In the left pane click DHCP and in the right pane select the 'On' option. This will enable the DHCP service. DHCP service uses DHCP pools to provide IP addresses.

Which of the following roles must be installed in order to deploy a DHCP relay agent on Windows Server 2016?

The DHCP server must be installed by an Enterprise Administrator.

What is Relay Agent in DHCP server?

A DHCP relay (agent) is a host that forwards DHCP packets between clients and servers that are not on the same physical subnet.

How do I add IPv4 DHCP relay agent protocol?

In the navigation pane, right-click DHCP Relay Agent, and then click Properties. 6. On the General tab, enter the IPv4 address of the DHCP servers that you want to provide DHCP services for the RRAS server's clients, click Add, and then click OK. the subnet to which this interface is attached and DHCP servers.

Where does DHCP relay agent should be installed?

In networks with multiple subnets, it is not feasible to place DHCP servers on each of the subnets where clients are physically located. For a multi-segmented network, the best configuration is to place the DHCP servers in a central location.

How do I use DHCP relay?

Select a trusted, optional, or custom interface and click Configure. From the drop-down list at the bottom of the page, select Use DHCP Relay. In the DHCP Server text box, type the IP address of a DHCP server and click Add. Repeat the previous step to add the IP addresses of up to three DHCP servers.

Which DHCP request option fills in the relay agent IP address?

DHCP relay agent fills the option 82 sub-option 11 field in the DHCP discovery packet with the client's gateway IP on the VTEP (which is the relay interface IP address of the VTEP) and the DHCP server returns a DHCP offer reply packet with option 54 set to the DHCP server Identifier.